Absorption voltage
Charging voltage target during the absorption stage, specified for the battery chemistry.
WEATHER ↗A–ZSearch the language of solar panels, battery monitors, lithium chemistry, DC-DC charging and campsite power. Every definition is written for real campervan owners.
No engineering degree required. Search by term or idea, then jump into the detailed chapters when you want to know more.
61 definitions
Charging voltage target during the absorption stage, specified for the battery chemistry.
Alternating current, typically 230V at UK mains sockets.
Absorbent Glass Mat; a type of sealed lead-acid battery.
Vehicle-driven electrical generator that supplies power to the vehicle electrical system.
A unit of electrical current. A 3A draw means charge is flowing at a rate of 3 amperes at that instant.
Amount of charge: one ampere for one hour equals 1Ah. It is not the same as watts or watt-hours.
Nominal charge the battery can store under specified conditions, often in Ah.
An assessment of capacity or internal condition compared with the battery’s original state, not identical to SOC.
Victron mains charger range; Vanilla has a 25A unit.
Short-range wireless link used by compatible Victron devices to talk to a phone.
Battery Management System. Internal battery electronics that monitor and protect battery operating conditions.
A load or charger whose negative return is connected outside the shunt’s measurement path.
Selection of conductor dimensions appropriate for current, voltage drop, installation and protection.
Percentage factor accounting for energy or charge not stored during charging calculations.
SmartShunt full-charge *detection* threshold, distinct from the charger’s voltage setpoint.
Percentage of a period when a fridge compressor operates.
Energy lost as heat or other inefficiencies when changing electrical voltage or current type.
Estimating battery charge by integrating measured current over time.
Precisely characterised low-resistance element used to measure current from a small voltage difference.
A battery monitor’s count of charge/discharge events using its own thresholds; definitions vary.
Information about where measurements came from and what they truly represent.
Direct current, used in the campervan’s leisure battery and common 12V circuits.
Electronic charger that regulates charge from a DC input such as the vehicle electrical system.
An unusually low state of charge; exact significance depends on chemistry, limits and context.
SmartShunt planning parameter used for time-to-go estimates; not an automatic hard cutoff.
Electric Hook-Up: externally supplied mains electricity at a campsite or other suitable source.
Lower charging voltage stage according to a charger’s battery profile.
Safety component intended to interrupt excessive current under specified conditions.
Internal battery feature that can warm cells using incoming charge power in supported Fogstar models.
One recorded observation per hour; not a complete trace of every second within that hour.
Device converting DC battery electricity into AC output. Vanilla has no fixed leisure-battery inverter.
1,000 watt-hours. Useful for larger energy totals.
Lithium iron phosphate, the cell chemistry used by Vanilla’s Fogstar leisure battery.
Protection against charging below the battery’s permitted temperature range.
Maximum Power Point Tracking: optimising the operating point of a solar panel while regulating charging.
Total measured current actually entering or leaving the battery after charging and loads offset.
Representative voltage used for rough system calculations, not a fixed voltage reading.
Victron DC-DC charger range; Vanilla uses a 12/12-30A model.
Power measured under standardised test conditions; not guaranteed actual field output.
Batteries connected to increase capacity at similar nominal voltage; requires compatible batteries and design.
Battery-monitor correction parameter for capacity behaviour at different discharge rates.
Photovoltaic: converting light into electrical energy.
Gradual loss of stored charge while a battery is not being used.
Batteries connected to increase system voltage; requires explicit manufacturer compatibility.
Victron battery monitor that measures voltage/current and estimates SOC, time remaining and history.
Victron range of solar charge controllers, including Vanilla’s MPPT 75/15.
Gradual discrepancy between the monitor’s calculated SOC and true battery charge.
A relatively steady SOC period, which can reflect balanced currents, inactivity or measurement behaviour.
Total electrical energy harvested over a period, usually shown by a controller in Wh or kWh.
Small electrical consumption from electronics that remain powered between uses.
Estimated proportion of usable battery capacity remaining as reported by a monitor or BMS.
Resetting the SmartShunt’s estimated SOC to 100% after genuine full-charge criteria are met.
Current threshold used with charged voltage and detection time to decide when the battery is full.
Adjustment used by some charger profiles; generally disabled for LiFePO₄ when manufacturer specifies.
Victron estimate of duration until the selected discharge floor under recent load conditions.
Capacity available under real operating conditions and selected reserve/cutoff limits.
Victron application for seeing live readings, history and settings on supported devices.
Electrical potential difference. Battery voltage depends on chemistry, charging, loading and temperature.
Reduction in voltage along cables and connections when current flows.
Rate of energy transfer. For DC circuits, approximately volts multiplied by amps.
Energy delivered or used: watts multiplied by hours.