THE
NIGHT
WATCH.
Outside, a cold Staffordshire night. Inside, a little grey campervan fighting to keep her warmth. The temperature sensors recorded every minute. Here is the story they told.
At ten o’clock on Saturday night, Vanilla was still warm. Not tropical, not shorts-and-T-shirt warm, but firmly in the high teens while November air pressed against her windows and bodywork.
And then something fascinating began to appear in the data: an almost mechanical rhythm. Warm up. Ease down. Warm up again. Every three-quarters of an hour or so, the interior temperature traced another little mountain across the chart.
Was this a campervan losing the battle against the cold—or a heating system doing its job? The numbers answer part of that question beautifully. The rest needs care, because a temperature sensor can show a pattern without identifying what caused it.
The night, written in temperature.
The orange line is Vanilla. The blue line is the air outside. In the full minute-by-minute record, the orange line repeats its rise and fall while the colder outside temperature gradually drifts down. Use the buttons to examine different parts of the night.
Inside vs outside — actual sensor readings
22:00 Saturday → 08:17 Sunday • minute by minute
Swipe left or right across the graphic to explore its full width.
Outside sensor stops recording at 07:51. The cabin continues to 08:17; the missing outside interval is intentionally left blank. These are temperature measurements, not a log of heater burner operation.
“She did not remain at one temperature. She kept coming back to roughly the same warmth, again and again.”
The solid finding
Across the 618 recorded overnight minutes, the cabin averaged 18.32°C and ranged from 17.2°C to 19.4°C. It did not fall into a sustained decline during the hours studied.
The important distinction
The 13.36°C average cabin-to-outside difference is a measured temperature gap for the 592 overlapping overnight minutes—not a measure of insulation quality or fuel efficiency on its own.
Thirteen little battles with the cold.
An unusually repeatable sawtooth pattern dominates the night. Each complete loop begins at a low, rises towards a peak, then returns to another low. The pattern could be consistent with cycling heat input, but it cannot independently prove the Webasto's burner timings.
The anatomy of one typical cycle
Median duration 46 minutes; mean rise and fall phases across 13 cycles
minutes
The phase labels describe measured cabin-temperature direction. They do not indicate confirmed heater on/off durations.
Tap a cycle to examine it
What changed as dawn approached?
Before 03:00 the measured warming segments averaged about 25.3 minutes. From 03:00 onward they averaged 30.0 minutes. The cooling segments remained near 18 minutes. That suggests the system may have had to work longer to recover the same cabin temperatures as outside conditions became colder—but heat output, ventilation, door opening and thermostat location were not logged, so the cause is not proven.
The moisture story.
Warmth is only half the overnight comfort picture. Relative humidity provides clues about dampness, but condensation depends on the temperatures of the windows and other interior surfaces.
Relative humidity through the night
Cabin and outside sensors • 22:00–07:51
Swipe horizontally to view the full graph.
The cabin averaged 47.3% RH from 22:00 to 08:17, whereas outside RH was generally higher. This is not evidence that the van had no condensation on its coldest surfaces.
Cabin dew point
The mean recorded overnight cabin dew point was 6.9°C. Condensation can form on surfaces colder than the surrounding air's dew point. No window or wall surface temperatures were measured.
Why 47% is useful
The cabin RH was mostly in the mid-to-upper 40s, rather than at very high levels. That is encouraging, but local moisture at windows, insulation voids and bedding can differ from the sensor location.
Inside Vanilla: where the warmth goes
Cinematic thermal concept • Webasto set to 16°C

AI-generated conceptual cutaway, not a photograph or measured airflow simulation. The outside minimum (4.5°C) and cabin average (18.32°C) occurred over different periods and must not be interpreted as simultaneous readings.
No guesswork disguised as data.
The article is based on the exact CSV exports supplied for Vanilla and Outside, not weather-forecast estimates. Here is the hourly breakdown, followed by the limitations that matter.
Hourly evidence ledger
Each row covers the following 60 minutes; the 07:00 row has outside readings only through 07:51. Separate cabin readings continue to 08:17.
| Hour from | Cabin mean | Cabin range | Outside mean | Cabin RH mean |
|---|---|---|---|---|
| 22:00 | 18.13°C | 17.3–19.4°C | 5.46°C | 48.7% |
| 23:00 | 18.50°C | 17.4–19.4°C | 5.44°C | 48.4% |
| 00:00 | 18.16°C | 17.2–19.4°C | 5.22°C | 48.0% |
| 01:00 | 18.33°C | 17.2–19.3°C | 5.15°C | 48.1% |
| 02:00 | 18.49°C | 17.3–19.2°C | 5.01°C | 47.3% |
| 03:00 | 18.18°C | 17.2–19.4°C | 4.81°C | 47.0% |
| 04:00 | 18.28°C | 17.4–19.1°C | 4.70°C | 46.8% |
| 05:00 | 18.47°C | 17.4–19.2°C | 4.67°C | 46.2% |
| 06:00 | 18.44°C | 17.2–19.4°C | 4.55°C | 46.2% |
| 07:00 | 18.18°C | 17.2–19.3°C | 4.66°C | 46.3% |
Every minute from 22:00 on 21 November to 08:17 on 22 November. No missing timestamps in this interval.
Every minute from 22:00 to 07:51. Outside values were not invented for the remaining 26 minutes.
Low-to-peak-to-low segments identified from the temperature series. The measurement period ends during a partial subsequent cycle.
What the sensor files cannot establish
They do not record Webasto ignition, fuel-pump activity, burner flame, fuel use, battery draw, air temperature at mattress height, window surface temperature or an independently logged thermostat setting. Previous H02/H03 concerns make a heater operating log particularly valuable, but the temperature pattern alone is not a fault diagnosis.
Did
Vanilla
win?
In terms of avoiding a sustained overnight temperature collapse, yes. As the outside sensor reached 4.5°C, the cabin continued to repeatedly return to about 19°C. That is a meaningful result.
But comfort is another question. The cabin spent 32.2% of the overnight readings below 18°C, and the sensor never needed to reach 20°C to satisfy the stated 16°C setting. Whether this was comfortable depends on sleeping arrangements, bedding, drafts, sensor placement and the heater setting.
Vanilla maintained warmth, but not a flat temperature. Her overnight signature is a steady average wrapped around a striking thermal heartbeat—and that is precisely what deserves the next investigation.
NIX Thermal Lab • Analysis of readings recorded on 21–22 November 2026 • Times in UK local time (GMT). Original editorial illustrations are conceptual and are not photographs or measurements. Built as a self-contained HTML article with no third-party scripts, fonts or network requirements.
Download overnight CSV evidenceTHE NIGHT.
IN MOTION.
Explore the actual minute-by-minute cabin and outdoor readings. Hover, tap or drag across the graph. The orange line is Vanilla's measured cabin temperature; the blue line is the outdoor sensor. The dashed line marks the confirmed 16°C thermostat setting.
The outdoor series ends at 07:51; later outside values are intentionally left blank. Chart readings are measurements, not direct Webasto burner telemetry.
THIRTEEN
HEATING HEARTBEATS.
Each orange segment is the observed rise from trough to peak, treated as Webasto ON for this model. Blue is the fall from peak to trough, treated as OFF. These are estimates based on the agreed slope assumption.
THE PRICE
OF A WARM NIGHT.
Adjust the price and assumed operating fuel rate. All cost figures update immediately. The default uses your actual £1.87/litre diesel price and the 0.18 L/h mid-case fuel rate.
Approximately 1.12 litres over 6 hours 14 minutes of inferred heating.
This is a scenario calculator, not a fuel-flow measurement. It excludes electricity and does not establish actual burner modulation. Heating time is extrapolated from the temperature rise/fall phases.
THE SETTING THAT CHANGED THE STORY.
There was one missing fact in the first investigation. We had been discussing whether Vanilla had reached 20°C. But that was never the target. The Webasto Air Top 2000 STC thermostat had been set to 16°C.
Suddenly the whole night reads differently. From 22:00 to 08:17, the interior sensor recorded 17.2–19.4°C, averaging 18.32°C. Every overnight cabin reading was above the stated 16°C thermostat setting. The outside air reached 4.5°C at 06:23.
The important caveat: the Webasto's control sensor and the independent cabin sensor may not be in the same place or measuring the same air. This is a temperature result, not proof that the heater's controls were operating exactly as designed.
WHEN THE LINE CLIMBS, THE HEATER IS ON.
For this experiment we adopt one deliberate working assumption: a rising cabin-temperature slope means Webasto ON; a falling slope means Webasto OFF. The graph therefore becomes an inferred heating log.
Extrapolating the mean ON/OFF proportions over the full 10 hours 17 minutes gives approximately 6 hours 14 minutes ON and 4 hours 3 minutes OFF. Those are inferred totals, not directly logged burner timings. The first and last cycles are incomplete.
The dawn mystery
Before 03:00, warming segments averaged about 25.3 minutes. After 03:00 they averaged about 30 minutes. It is consistent with more heating effort as the night progresses, although it cannot tell us whether colder air, thermostat behaviour, modulation or another factor caused the difference.
HOW MUCH DID THE NIGHT COST?
Now for the part every campervan owner wants to know. At the diesel price actually paid — £1.87 per litre — we can model the Webasto's fuel use against the estimated 6 hours 14 minutes of heating. The Air Top 2000 STC's indicative fuel-consumption range is 0.12–0.24 litres per hour while operating; the true rate varies with heat output.
Our £2.10 working estimate corresponds to about 1.12 litres consumed over the modelled heating time. If a future night behaved identically, that would be about £14.69 for seven nights or £62.94 for thirty nights. These are scenarios, not fuel measurements or forecasts.
METHOD: 6 h 14 min × assumed 0.12 / 0.18 / 0.24 L/h × £1.87/L. Results rounded. This model excludes electrical energy and does not independently measure fuel flow, burner modulation, ignition or residual heat. The inferred heating duration relies on temperature slopes rather than a direct Webasto operating log.
VANILLA WON THE NIGHT.
The temperature record does not show a van surrendering to the cold. It shows a little grey campervan holding her cabin above the selected thermostat setting while the November air cooled outside. The repeated sawtooth pattern tells us that the interior warmed and cooled in an orderly rhythm. On our agreed assumption, it also offers a useful estimate of heater duty cycle and overnight diesel cost.
There are still unanswered questions. Was the Webasto modulating or switching fully on and off? How closely did its thermostat sensor match the independent sensor? Would the cycle length change in a genuine sub-zero night? And what would a direct fuel measurement reveal?
That's the next Night Watch. For now, the data tell a compelling story: a 16°C setting, an 18.32°C cabin average, thirteen complete temperature cycles, and an indicative diesel bill centred on £2.10.
SOURCE NOTES: NIX original overnight sensor investigation, 21–22 November 2026. Cabin: 978 full-period readings, 618 overnight readings. Outside: 952 full-period readings, ending at 07:51. The final 26 minutes of the cabin trace have no paired outdoor readings. The 16°C thermostat setting and £1.87/L diesel price were subsequently supplied by the owner. The cinematic hero image is AI-generated artwork, not a documentary photograph.

WEATHER ↗A–Z