WEATHER ↗A–Z
← ALL STORIES
Read the text version

How I Charge Vanilla's 105Ah Fogstar | NIX Stories Edition

NIX DRONESVANILLA · POWER LABThe batteryThe chargersReal readingsCharging examplesVideosFAQ
NIX power lab · November 2026

How I charge
Vanilla's 105Ah
lithium battery.

One Fogstar. Two Blue Smart chargers. A solar panel. An Orion. And a surprising amount of science behind the freedom to park anywhere.

⚡ 105Ah LiFePO₄🔌 10A + 25A mains options☀️ 200W solar🚐 30A DC–DC
AI editorial illustration of Vanilla · not a documentary photograph
FOGSTAR DRIFT 105AHVICTRON BLUE SMART 10ABLUE SMART 25APV LOGIC 200W SOLARSMARTSOLAR MPPT 75/15ORION-TR SMART 30ASMARTSHUNT 500AVANILLA POWER LABFOGSTAR DRIFT 105AHVICTRON BLUE SMART 10ABLUE SMART 25APV LOGIC 200W SOLARSMARTSOLAR MPPT 75/15ORION-TR SMART 30ASMARTSHUNT 500AVANILLA POWER LAB
01 / The heart of the van

Freedom starts with a battery.

Give me a lovely spot, a decent view and a functioning fridge, and I'm a happy camper. But the heating fan, the lights, the fridge controls and all the little conveniences need electricity—even when the engine is switched off.

That's why Vanilla carries a Fogstar Drift 105Ah LiFePO₄ leisure battery. Instead of simply hoping there's enough charge left, I can see what goes in, what comes out and how much remains.

The clever part isn't simply storing electricity. It's giving the battery several intelligent ways of getting it back.

Its built-in battery management system provides protection and Bluetooth monitoring, while integrated heating supports its cold-weather charging strategy. The BMS doesn't magically make every installation safe; correct settings and properly rated wiring still matter.

AI-generated editorial close-up of Vanilla campervan parked beside a lake at sunset
VANILLA · AI-CREATED CAMPERVAN PHOTOGRAPHY
105AhNominal capacity
~1.28kWhEnergy on Fogstar spec sheet
4 pathsCharging configurations
1 appVictronConnect monitoring
02 / Charging explained

Four routes back to full.

Here's how I replenish the Fogstar. The two Blue Smart units are alternative mains chargers, not two devices I routinely run together; sunlight and the vehicle alternator provide the other main options.

MAINS / 01
🔌

Victron Blue Smart IP65 12/10

My steady 10A charger. Plugged into mains electricity, it supplies controlled DC charging. Its lithium algorithm progresses through charging stages rather than blindly holding one voltage forever.

See how the charging stages work ↗
MAINS / 02
⚡

Victron Blue Smart 25A

The higher-current mains option. In ideal bulk-charge conditions, 25A can replenish a depleted battery much faster than 10A—provided the circuit, battery and charger settings all permit it.

Compare charging situations ↗
DAYLIGHT / 03
☀️

200W panel + SmartSolar MPPT 75/15

My PV Logic panel turns daylight into electricity. The MPPT finds an efficient operating point and controls the charge delivered to the battery, up to its 15A output limit. A 200W rating is not a promise of 200W all day.

See its real November performance ↗
ON THE ROAD / 04
🚐

Orion-Tr Smart 12/12-30A

While the engine is supplying suitable electrical power, the Orion can convert it into controlled leisure-battery charging. Its engine detection and input protections help manage modern alternator behaviour.

Follow the energy flow ↗
The why behind the watts

More energy in the battery.
More freedom on the road.

Not an enormous battery bank. Not a complicated off-grid power station. Just a flexible system that makes the most of mains, movement and daylight.

AI-created editorial scene; equipment specifications are described separately.
03 / The real experiment

What the numbers said at 11:18 am.

This is not a made-up charging chart. The readings below come from an actual VictronConnect screenshot recorded on Sunday 22 November 2026, when Vanilla was being charged from mains and solar.

VictronConnect · Charging snapshot

RECORDED READING
Battery voltage13.39V
Net battery current+13.23A
Shunt state of charge30%
Blue Smart output10.00A
Solar production55W
Solar battery current4.00A

The rough current balance

10A mains4A solar≈ 14A sources · 13.23A net into battery
SmartShunt battery power177W
SmartSolar yield so far that day60Wh
Blue Smart voltage13.74V
Orion statusOff
Blue Smart stageBulk

Important: this is a historical screenshot, not a live connection. The 30% figure is the SmartShunt estimate, which depends on calibration and synchronisation.

Actual VictronConnect screen at 11:18 on 22 November 2026 showing Blue Smart at 10 amps, SmartShunt at 13.39 volts and 13.23 amps, and SmartSolar at 55 watts.
Energy detective

Where did the charging current go?

10A + 4A ≈ 14A

The sources together reported about 14A, but the battery was receiving 13.23A net. The roughly 0.77A difference is consistent with equipment consumption and small timing or measurement differences—it is not an independent measurement of the van's loads.

We also saw a 0.35V difference between the charger's 13.74V reading and the battery's 13.39V. That's worth investigating at the connections if needed, but it does not prove the existing 50A breaker is faulty.

04 / Visual guide

Follow the electricity.

The simplified energy map below shows which equipment supplies energy, where the Fogstar sits, and where that stored electricity ultimately goes. It is not a literal wiring schematic.

🔌
Mains electricity10A or 25A Blue Smart · alternative chargers
☀️
200W solarThrough SmartSolar MPPT 75/15
🚐
Vehicle alternatorThrough Orion-Tr Smart 30A
🔋
FOGSTAR
DRIFT 105Ah
LiFePO₄ storage
💡
Vanilla's equipmentFridge, lights, diesel-heater controls
📱
SmartShuntBattery measurement, not a charger
🔋
Anderson connectionJackery charging when used

All circuits require suitable protection, cabling and settings. The SmartShunt monitors battery current; it is not an additional energy destination or charging source.

05 / Practical power lab

Four charging situations. One battery.

Here is what each charging route means in plain English. The figures below describe rated maximum charger currents, not real-time measurements or a prediction of battery charge times.

🌤️

Parked off-grid

0–200W

My roof-mounted PV Logic panel can provide up to its 200W rated output in suitable conditions, with the Victron MPPT controlling charging. At night, solar production falls to zero.

Solar MPPT 75/15
🔌

At home: the 10A Blue Smart

Up to 10A

The everyday mains charger. On 22 November it was supplying 10.00A in Bulk mode, while solar added another 4.00A from the roof.

Measured 10.00A that morning
⚡

Faster mains charging: 25A

Up to 25A

The second Blue Smart is my higher-current mains option. It is an alternative to my 10A unit, not something I automatically run alongside it.

Model family / maximum rating
🚐

Driving: the Orion 30A

Up to 30A

The DC–DC charger can replenish the leisure battery from the vehicle's electrical system while I'm driving, when its configured conditions allow.

Orion-Tr Smart 12/12-30

What do the numbers actually mean?

Amps (A) measure current. Amp-hours (Ah) measure accumulated charge. Watts (W) measure power: roughly volts × amps.

For example, a 10A current sustained for five hours represents 50Ah before accounting for current taper, other loads and losses. Solar production, charger settings, battery temperature and charging stage all affect real performance.

10A
Blue 10A
25A
Blue 25A
30A
Orion
15A
MPPT limit

Maximum device ratings, not measured simultaneous currents. Actual safe charging depends on the whole installation.

06 / Charger intelligence

Bulk. Absorption. Storage.

Three steps in a typical lithium-compatible charging sequence, explained with illustrated voltage and current curves. No hidden tabs or controls.

Stage one

Bulk — the fast part

The charger supplies current up to its selected limit while battery voltage rises toward the programmed absorption target. On 22 November, my 10A charger was in Bulk at 10.00A.

Stage two

Absorption — the careful finish

At the charging target voltage, current normally reduces as the battery approaches full. Real charge time therefore isn't simply missing amp-hours divided by the charger's rated amperage.

Stage three

Storage — maintaining a full battery

The Blue Smart lithium programme uses a lower storage voltage to maintain the battery after charging. It does not use the same float sequence as its lead-acid programmes; follow the selected lithium profile and Fogstar guidance.

Curves are explanatory illustrations, not measured data.
07 / Watch & learn

Real videos. Real engineering.

These are real YouTube videos, rather than AI-generated footage of the hardware. Tap the image or title to watch on YouTube. No in-page video scripts or extra windows triggered by a single tap.

Thumbnail for independent Victron Orion-Tr Smart 12/12-30 installation guide▶

Orion-Tr Smart 12/12-30 — real camper installation

TomyKat · Independent Spanish-language walkthrough of the same 30A charger family. Not footage of Vanilla.

Watch this real video on YouTube ↗

Videos require an internet connection and may be subject to YouTube embed settings, cookies or regional restrictions. The direct links are always available.

08 / A day in Vanilla

Electricity follows the adventure.

One of the joys of having several charging methods is not needing the same electrical supply all day.

Morning
☕

Wake up warm

The Fogstar has been powering the fridge, lights and Webasto controls during the night.

On the move
🚐

Let the Orion work

When vehicle conditions permit, the DC–DC charger can replenish the battery as I drive.

Afternoon
☀️

Harvest daylight

Parked up, solar continues to contribute if there's enough sun—even on cooler days.

Back at home
🔌

Plug in intelligently

Choose an appropriate Blue Smart charger and let its lithium-compatible algorithm do the work.

The bit that really matters

It's not about owning the biggest battery.

It's about pulling into a beautiful spot, putting the kettle on and knowing the essentials will keep working. And yes, I'll probably check the amps before my tea's brewed.

AI-created illustration of Vanilla beside a lake.
09 / Common questions

What people usually ask.

Answers for anyone thinking of fitting lithium, solar or DC–DC charging to their own camper.

Can I use both mains chargers together?

They are separate charging options. Combining chargers may be possible in a properly designed system but isn't something to assume is safe just because both devices are Victron. Total charging current, control settings, battery limits and wiring protection have to be checked. I treat them as alternatives in this article.

Does my 200W panel always produce 200W?

No. That's a laboratory-rated maximum under specified conditions. Sun angle, clouds, shade, panel temperature and the battery's state can all reduce the actual watts. In my real November screenshot, it was producing 55W.

What's the difference between amps and amp-hours?

Amps (A) measure the instantaneous flow of electric current. Amp-hours (Ah) describe accumulated charge over time. A 10A charge sustained for five hours is 50Ah before accounting for losses, current taper and any power used at the same time.

Why do I need a SmartShunt?

With lithium, voltage alone doesn't tell the whole story. The SmartShunt monitors battery current over time and provides a state-of-charge estimate. It must be configured and synchronised correctly to remain reliable.

Is a 0.35V charger-to-battery difference bad?

Not necessarily. I observed 13.74V reported by the Blue Smart and 13.39V at the battery. Wiring and connection resistance, the different measurement locations and timing can explain some difference. It doesn't prove a particular breaker is faulty; diagnosis requires measurements at the relevant terminals.

Can lithium batteries be charged in freezing weather?

Charging cold lithium cells can damage them. My Fogstar Drift has a BMS and integrated heating to manage its cold-weather charging approach, but correct installation and manufacturer guidance are essential. Battery temperature is more important than simply checking the outside air temperature.

What does the Anderson connector do?

On Vanilla it provides a connection used both for charging and for supplying a Jackery portable power station. The installed 50A breaker and cable ratings need to suit the actual loads; the connector rating alone doesn't establish circuit safety.

What lithium charging voltages should I use?

Fogstar's published Victron guidance gives 14.2V for bulk/absorption and 13.5V for float/storage, while the battery product page also lists 14.4V as a recommended charging voltage. Exact settings depend on the device profile and documentation; don't blindly copy a voltage from someone else's van.

10 / Evidence & specs

Sources, not guesswork.

This article combines my own VictronConnect screenshot with the product specifications published by Fogstar and Victron. The images showing Vanilla are AI editorial illustrations. The charging calculator is explicitly theoretical, while the YouTube videos above are genuine external material.

Technical transparency: The Blue Smart IP65 12/10, Orion-Tr Smart 12/12-30A, SmartShunt 500A/50mV and MPPT 75/15 were identified from the actual November 2026 VictronConnect screen. The separate Blue Smart 25A charger and 200W panel are described from the owner's equipment details. The circuit design, larger charger's exact variant, installation ratings and settings have not been independently audited. Do not use this article as installation instructions.

NIX DRONESVANILLA · POWER LAB

My campervan. My equipment. Real readings. Made for curious people.

Written 22 November 2026 · AI-assisted editorial imagery

↑ Back to the beginning
Article design imageArticle design imageArticle design image